For example, the outer locator at Dallas/Love Field (DAL) is identified as “DA.” The middle locator at DAL is identified by the last two letters “AL.” The coding identification of the outer locator consists of the first two letters of the three-letter identifier of the associated LOC. ![]() When used in conjunction with an ILS front course, the compass locator facilities are collocated with the outer and/or MM facilities. Compass Locator. Compass locators are low-powered NDBs and are received and indicated by the ADF receiver.The back-course marker, where installed, indicates the back-course FAF. It indicates the point at which an aircraft is at the decision height on the glide path during a Category II ILS approach. The inner marker (IM), where installed, is located on the front course between the MM and the landing threshold. The OM is located on the localizer front course 4 to 7 miles from the airport to indicate a position at which an aircraft, at the appropriate altitude on the localizer course, will intercept the glide path The MM is located approximately 3,500 feet from the landing threshold on the centerline of the localizer front course at a position where the glide-slope centerline is about 200 feet above the touchdown zone elevation.A marker beacon may also be installed to indicate the FAF on the ILS back course. A third beacon, the inner, is used where Category II operations are certified. Marker Beacons. Two VHF marker beacons, outer and middle, are normally used in the ILS system.At 10 NM from the point of touchdown, this represents a vertical distance of approximately 1,500 feet, narrowing to a few feet at touchdown. The system provides no vertical guidance for approaches on the back course. Unlike the localizer, the glide-slope transmitter radiates signals only in the direction of the final approach on the front course.At locations where standard minimum obstruction clearance cannot be obtained with the normal maximum glide-slope angle, the glide-slope equipment is displaced farther from the approach end of the runway if the length of the runway permits or, the glideslope angle may be increased up to 4°. The glide-slope projection angle is normally adjusted to 2.5° to 3.5° above horizontal, so it intersects the MM at about 200 feet and the OM at about 1,400 feet above the runway elevation. The course projected by the glide-slope equipment is essentially the same as would be generated by a localizer operating on its side.The glide-slope equipment is housed in a building approximately 750 to 1,250 feet down the runway from the approach end of the runway, and between 400 and 600 feet to one side of the centerline.The glide path is the straight, sloped line the aircraft should fly in its descent from where the glide slope intersects the altitude used for approaching the FAF, to the runway touchdown zone. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |